It is recommended to choose the following methods for trial implementation 1. Pre-treatment section. The pre-treatment section of glass wine bottle spraying includes pre-off, main off, surface adjustment, etc. If it is in the north, the temperature of the main off part should not be too low, and heat preservation is required. Otherwise, the treatment effect is not ideal; 2. The preheating section. After pre-treatment, it will enter the preheating section, which usually takes 8-10 minutes. When the glass bottle reaches the powder spraying room, the sprayed workpiece must have a certain amount of residual heat to increase the adhesion of the powder; 3. Glass wine bottle blowing Ash purification section. If the process requirements of the sprayed workpiece are relatively high, this section is indispensable. Otherwise, if there is a lot of dust on the workpiece, the surface of the processed workpiece will have a lot of particles, which will reduce the quality; 4. Powder spraying section. Glass bottle my country's traditional beverage packaging container, glass is also a kind of packaging material with a long history. With many packaging materials pouring into the market, glass containers still occupy an important position in beverage packaging, which is inseparable from its packaging characteristics that other packaging materials cannot replace. The key point in this paragraph is the technical problem of the dusting master (Emerson). If you want to create a good quality (Character), it is still worthwhile to spend money to hire a skilled master. 5. Drying section. Attention should be paid to the temperature and baking time (explanation: baking things with fire). The powder is generally 180-200 degrees Celsius, depending on the material of the workpiece. Also, the drying furnace should not be too far away from the powder spraying room, generally 6 meters is better.